Curtain rods sit-in brackets that connect to the wall with screws and come in various fashions. You might want to modify the rod and brackets to to suit the style of the curtain when you substitute your drapes. Replacing your curtains could be as easy as sliding off the curtains or eliminating the bracket in the wall and getting the curtain rod aside and installing a new one.

Measure width and the height of your window. The width measurement to obtain the width of your curtains. Use these measurements to buy curtains that are new.

Remove the curtains and curtain rod.

Remove the screws from your curtain rod brackets and eliminate them in the wall.

Measure 2″ from either end of the window and mark this point on the wall. This can be where you are going to install the new window brackets.

Hold the mounting brackets up to the wall on the 2 inch level and mark the screw-holes onto the wall using a pencil.

Drill pilot holes on the pencil marks.

Hold up the bracket and align the screw holes using the pilot holes. Drive the supplied screws using an electric screwdriver to the wall. Install the bracket the way.

Place a carpenter’s level on both brackets to make sure that they’re level. When they’re not level, tighten the best screws and loosen the screws loosen the best screws and tighten the screws to reduce a bracket, or to increase a bracket, till they’re level.

Remove any conclusion parts in the curtain rod that is new. Pull aside the curtain rod if it ends with right-angled parts that tilt onto the brackets.

Slide the curtains threading the rod through the very best pocket, tabs or rings of the curtains.

Set the curtain rod or tilt the finish that was angled onto the prongs of the brackets and snap it set up.