Installing draperies warms up your area by including colour and texture, enhancing the look and feel of the area. Because curtain rods generally have a large amount of parts as well as the rod installing components is daunting. Installing components is an easy process it is possible to complete with simple resources while it looks just like lots of work.

Measure and mark in a spot over the window-frame to where the rod will go to to point. The area of the mark depends on your drapes as well as the window. A mark at about 4″ over the window is perfect for drapery that falls below the sill. For drapery that falls to the ground, calculate the size that is drapery, and include 1-inch to that measurement. Mark your place at this peak from the ground. Make sure the ground is grazed by the bottom of the material when positioned in the peak of your mark.

Subtract the width of the window in the rod width. Divide this amount and mark an area as of this measurement on every side of the window in the peak your mark. These marks show where you’ll install the finish brackets.

Measure the the length between these two marks to make sure that it’s equivalent to the rod width.

Drill a hole at all the places that are marked. When you’ll be utilizing a middle bracket at the same time, mark the area in the middle of the marks and pre-drill a hole there as well. When you’re covering a huge window, middle brackets needs to be mounted no more than 30-inches from every bracket.

Position the brackets on the wall s O the bottom hole of the bracket lines up using the pre-drilled hole. Insert a screw to the bracket- holes and tighten having a screwdriver.

Place the rod. Set an even on the rod to generate sure it’s straight.

Install a finial on one end-of the rod and slide your curtain within the rod and install the finial on another end. Place the rod.