Many cupboard kick plates are made of compressed particleboard or fiberboard using a layer of laminate on best. After just several years of normal residence use, the manufacturer’s kick-plate can degrade. Installing a rubber kick plate over the kick-plate that is current can prolong the life span of the cupboard foundation. In case your cupboards have no kick-plate that is current, install one prior to installing the rubber kick-plate. It’s possible for you to buy low-cost alternative kick plates from a cupboard maker or create your own from 1/2-inch- plywood.

Corners First

Apply base adhesive in slim, zigzagging lines across the backside of a corner area of of rubber cove base. In the event the maker suggests -on adhesive, spread the adhesive on the kick-plate corner using a trowel or on the rear of the molding.

Press the corner area from the kick-plate in the interior corner or around the corner of the kick-plate.

Hold the foundation from the corner before the adhesive sets.

Let the corner sections dry before installing the the rest of the foundation.

General Installation

Measure the amount of the cabinet’s kick-plate. When there’s a a large part area in location, measure to the fringe of of the corner piece in the end of the kick-plate.

Measure a strip of rubber cove base to the kick-plate size measurement and mark it using a pencil.

Place the lipped-fringe of of a carpenter’s square on the upper edge of the rubber cove base and align the square’s 90-degree corner with all the pencil mark.

Trace the square’s leg on the other side of the cove base using a pencil, creating a straight-cutting mark.

Set the foundation on a function table without worrying about harming the area underneath, where it is possible to cut or scrap board.

Place the suggestion of a utility knife and gradually drag the knife across the line, slicing through the foundation.

Rubber cove base adhesive over the whole backside of the foundation in slim, zig zagging lines if needed, or apply the adhesive having a notched trowel.

Press the cove base from the cabinet’s kick plate. Butt the end-of the cove foundation tightly contrary to the fringe of of the corner area when there’s a a large part area in place.

Wipe off extra adhesive, if required, utilizing solvent and a rag -centered cleaner that’s recommended by both the cove foundation adhesive producer and also the base manufacturer. Wipe-off excessive using a rag dampened with basic water in the event the adhesive is watersoluble.

See related