Where artwork does not match tapestries are perfect for decorating partitions that are curved. Simply because they are versatile and gentle, tapestries comply with the curved-Wall form. They perform well both on both convex and concave surfaces. The hanging directions rely on if the back of the tapestry is outfitted or bare with hanging a-rod pocket or tabs.
Hanging Techniques
Since the mounting components should comply with the contour of the wall, by hanging a tapestry on a wall that is curved, you are limited to to 2 techniques. Hang it from a versatile curtain rod meant for an arched or bow-window, in case your tapestry has a rod pocket or again tabs. In the event the tapestry features a simple again, you will need to to hold it using hookandloop tape.
Preparing the Wall
With both hanging technique, begin by obtaining the studs in your wall and measuring the width of the tapestry. To get the wall studs, operate a studfinder over the wall. Mark the the location using a pencil when it beeps. For the curtain rod technique, choose a rod that is 1-inch shorter than the width of the tapestry. The duration that is somewhat shorter allows the tapestry stay the star; its own brackets and the rod will not display. Mount a middle bracket as well as two end brackets on the wall. Mount extra brackets at the places — or if your tapestry is large or broad — in case your best placement signifies you-can’t mount them on studs. To to hold your tapestry using hookandloop tape, observed bender board 1/2 inch shorter than the the. of tapestry’s Bender board is versatile plywood you will find in the gardening division of a hardware store’s. Screw the bender board to the wall in the studs. Cut 2 inch-wide, self adhesive hook-and-loop tape to the board size, then affix the looped half over the board’s leading edge.
Preparing the Tapestry
Rod -pocket up tapestries to the curtain rod brackets. Mark the rod pocket in the bracket places, and after that cut a slit to the pocket at these places. In the event the rod pocket reaches the ends of the tapestry, minimize slits that are extra 1 inch from every end. In the event you are hanging the tapestry with hookandloop tape, cut 2inch-extensive, sew-on tape 1/2 inch shorter than the the. of tapestry’s Center the delicate half of the hookandloop tape over the most notable edge of the tapestry. Sew the tape to the tapestry yourself.
Hanging the Tapestry
Slide the rod through the again tabs or rod pocket in the event that you are hanging your tapestry from a curtain rod. Mount the rod on the brackets in accordance with the instructions of the manufacturer’s. While other put on them, some rods are made to relaxation on the brackets. For the hookandloop tape approach, hang the tapestry by pressing the tape on the tapestry. Run your hand over the amount of the tape to ensure the tapestry is fixed to the wall.