Wood flooring that show off the grain and beauty of the wood are an instantaneous eye-catcher in a house. Renovating is well worth your investment, especially when the flooring are antinque. The character and history of the wood are shown after the cleaning. When you are completed, the floor will still show the age of the house, but without the dark layers of wax and varnish which conceal the inherent beauty of a hardwood flooring.
Remove any staples or nails from the floor’s surface. Be methodical, or you may tear up your sandpaper the moment the sander catches on a nail.
Sand down the floor using all the power sander, functioning in the path of these boards, rather than across them. Start with the coarsest grade of sandpaper and change to the finer grit after the majority of the surface was taken away. Come close to the borders as possible. Clean up the border of the space using a hand-held sander. Any wood dust generated in the sanding.
Wipe the floor with a rag moistened with plain water down. When the rag was soiled with all the old end, rinse it in fresh water. Eliminate as much of the old dust and finish as you can. Maintain a fan in the window to exhaust any air-borne dust out of the house. Vacuum the cracks between each floor board to get rid of any hidden dust.
Fill in almost any big holes with wood filler. This really is a putty that comes from smallish tins which come in a variety of colors to match your flooring. Fill in the hole using a scraper, smooth and let to dry in accordance with the directions.
Apply a coat of wood sealer to close the pores from the wood flooring surface. This really is a thin solution that is easily painted with a paintbrush. It’ll definitely leave a smooth surface which can hold an even blot or flooring finish and flaunt the grain at the same moment. Allow it to dry for approximately two hours.
Cover the newly sealed floor using a polyurethane or wax coating to keep soil from getting into the grains of the wood. Maintain the coating light in colour so that the age of the floor can still be observed. Paint it with a brush or applicator functioning in the directions of the flooring boards, maintaining the top edge wet. Use at least three coats to get a challenging end and allow a couple hours’ drying time between each coat; follow the directions for the particular merchandise you use. Some applications take a light sanding between coats for greater adhesion so read the special directions on the packaging.
Dry the floor for 2 or 3 days to let it cure. Place your furniture set up instead of slipping or scuffing it across the floor. Do not clean the floor other than using a light sweeping for at least a week, then utilize a lightly damp mop to clean up any soil.